Installed 5-speed manual gearbox 0AF

Chapter overview

• Technical data
  1
• 1 Safety information
  1
• 1.1 Safety measures when working on vehicles with a start/stop system
  1
• 2 Identification
  2
• 2.1 Gearbox identification
  2
• 3 Repair instructions
  3
• 3.1 General repair instructions
  3
• 4 Technical data
  5
• 4.1 Allocation gearbox - engine
  5
• 4.2 Capacities
  5
• 5 Overview - power transmission
  6
• 6 Electrical components
  8
• 6.1 Overview of fitting locations - electrical components
  8
• Clutch
  10
• 1 Clutch mechanism
  10
• 1.1 Overview of fitting locations – clutch mechanism
  10
• 1.2 Assembly overview - pedal cluster
  12
• 1.3 Assembly overview - clutch hydraulics
  14
• 1.4 Removing and installing bearing bush
  15
• 1.5 Removing and installing clutch position sender G476
  16
• 1.6 Removing and installing over-centre spring
  17
• 1.7 Removing and installing clutch pedal
  19
• 1.8 Removing and installing mounting bracket
  21
• 1.9 Checking clutch master cylinder and clutch slave cylinder
  23
• 1.10 Removing and installing master cylinder
  24
• 1.11 Removing and installing clutch slave cylinder
  25
• 1.12 Removing and installing lines for clutch mechanism
  27
• 1.13 Bleeding clutch mechanism
  29
• 2 Clutch
  31
• Controls, housing
  32
• 1 Selector mechanism
  32
• 1.1 Installation position - selector mechanism
  32
• 1.2 Assembly overview - gear knob and cover
  34
• 1.3 Assembly overview - selector mechanism
  35
• 1.4 Removing and installing gear knob
  36
• 1.5 Removing and installing selector mechanism
  38
• 1.6 Repairing selector mechanism
  40
• 1.7 Adjusting selector mechanism
  43
• 1.8 Checking selector mechanism
  46
• 2 Removing and installing gearbox
  47
• 2.1 Removing gearbox
  47
• 2.2 Installing gearbox
  54
• 2.3 Specified torques for gearbox
  57
• 3 Assembly mountings
  58
• 3.1 Assembly overview - assembly mountings
  58
• 4 Transporting gearbox
  60
• 5 Gear oil
  61
• 5.1 Checking gear oil level
  61
• 5.2 Draining and filling gear oil
  62
• 6 Dismantling and assembling gearbox
  64
• 6.1 Assembly overview - selector unit
  64
• 6.2 Removing and installing selector unit with gearbox installed
  65
• 6.3 Repairing selector unit
  68
• 6.4 Renewing selector shaft seal
  69
• 7 Gearbox housing, clutch housing
  71
• Gears, shafts
  72
• 1 Input shaft
  72
• 2 Output shaft
  73
• Final drive - differential
  74
• 1 Oil seals
  74
• 1.1 Overview of fitting locations - seals
  74
• 1.2 Renewing left seal
  75
• 1.3 Renewing right oil seal
  77
• 2 Differential
  81