Simos injection and ignition system

Kapitelübersicht

• Self diagnosis
  1
• 1 Self diagnosis
  1
• 1.1 Self diagnosis
  1
• 1.2 Function
  1
• 1.3 Technical data of self diagnosis
  1
• 1.4 Connecting fault reader V.A.G 1551 and selecting engine electronics control unit
  2
• 1.5 Coding Simos control unit
  3
• 1.6 Interrogating and erasing fault memory
  4
• 1.7 Fault table
  6
• 1.8 Final control diagnosis
  12
• 1.9 Read measured value block and basic settings
  16
• 1.10 Display group overview
  16
• Mixture preparation, Injection
  19
• 1 Simos injection and ignition system
  19
• 1.1 Simos injection and ignition system
  19
• 1.2 Fitting locations overview
  19
• 1.3 Servicing injection part
  22
• 1.4 Dismantling and assembling intake manifold - Upper part
  29
• 1.5 Dismantling and assembling intake manifold - Lower part
  31
• 1.6 Dismantling and assembling air cleaner
  32
• 1.7 Safety precautions
  34
• 1.8 Rules for cleanliness
  34
• 1.9 Technical data
  34
• 1.10 Idling check
  35
• 1.11 Performing basic setting
  36
• 1.12 Checking Lambda probe and Lambda control
  37
• 1.13 Checking Lambda probe heating
  40
• 1.14 Checking engine operating mode
  42
• 1.15 Checking air mass meter
  43
• 1.16 Checking throttle valve control part
  46
• 1.17 Checking coolant temperature sender
  52
• 1.18 Checking intake air temperature sender
  55
• 1.19 Checking engine speed sender
  57
• 1.20 Checking speed signal
  58
• 1.21 Checking control unit voltage supply
  61
• 1.22 Matching engine electronic control unit to electronic immobilizer
  62
• 1.23 Checking signal from air conditioner compressor
  63
• 1.24 Checking starter signal
  64
• 1.25 Checking injectors
  65
• 1.26 Checking fuel pressure regulator and holding pressure
  68
• 1.27 Checking intake air system for leaks (unmetered air)
  70
• Ignition system
  71
• 1 Simos injection and ignition system
  71
• 1.1 Simos injection and ignition system
  71
• 1.2 Servicing ignition part
  71
• 1.3 Safety precautions
  75
• 1.4 Test data, spark plugs
  75
• 1.5 Checking position of distributor
  75
• 1.6 Removing and installing distributor
  76
• 1.7 Checking Hall sender
  79
• 1.8 Checking knock sensor
  81
• 1.9 Checking ignition transformer
  82
• 1.10 Checking ignition transformer output stage
  83