Propshaft and rear final drive

Chapter overview

• Technical data
  1
• 1 Safety information
  1
• 1.1 Safety measures when working on vehicles with a start/stop system
  1
• 2 Identification
  3
• 2.1 Identification of final drive
  3
• 3 Repair notes
  4
• 3.1 General repair instructions
  4
• 3.2 Gaskets and seals
  5
• 3.3 Nuts and bolts
  5
• 3.4 Notes on performance test
  5
• 3.5 Oil
  5
• 4 Technical data
  7
• 4.1 Allocation final drive - engine
  7
• 4.2 Capacities
  8
• Final drive - differential
  9
• 1 Final drive
  9
• 1.1 Removing and installing final drive
  9
• 2 Assembly mountings
  13
• 2.1 Assembly overview - assembly mountings
  13
• 2.2 Removing and installing bonded rubber bush on rear final drive
  14
• 2.3 Removing and installing bonded rubber bush on rear gearbox carrier
  17
• 3 Gear oil
  23
• 3.1 Checking gear oil level
  23
• 4 High performance oil for all-wheel drive coupling
  25
• 4.1 Checking fluid level in all-wheel drive coupling
  25
• 4.2 Draining and replenishing high performance oil for all-wheel drive coupling
  26
• 5 Oil seals
  30
• 5.1 Renewing right oil seal
  30
• 5.2 Renewing left seal
  34
• 5.3 Renewing input shaft seal
  38
• 6 Differential lock
  40
• 6.1 Function of differential lock
  40
• 6.2 Components of differential lock
  40
• 6.3 Removing and installing actuator for differential lock
  41
• 6.4 Renewing bellows on rear final drive
  43
• 7 All-wheel drive coupling
  44
• 7.1 Assembly overview - all-wheel drive coupling
  44
• 7.2 Checking function
  45
• 7.3 Removing and installing pump for all-wheel drive coupling
  46
• 7.4 Removing and installing all-wheel drive coupling
  48
• 7.5 Removing and installing control unit
  50
• 8 Propshaft
  51
• 8.1 Assembly overview - propshaft
  51
• 8.2 Removing and installing propshaft
  53
• 8.3 Removing and installing centre propshaft bearing
  59
• 8.4 Checking constant velocity joint
  64